Safety operation specification for guide rail grinder

1。 Staff must wear good clothes and female workers must wear good clothes for work.

2。 Check whether the machine parts are complete, whether the safety protective clothing is in good condition, whether the key wire rope is damaged, etc. before starting work.

(3) The rotating or sliding parts of the machine tool and the guide of the Shaw injection lubricating oil.

4. Clean the sundries on the bed and around the sail so as not to hinder the work and cause accidents. Guide, clean it together.

5。 It must be good to load workpieces. When sifan should be hoisted together, delete the light when you and one person command.

6。 The grinding workpiece must be placed stably, and the center line of the workpiece must be guided by the parallel machine tool and reliably clamped.

7. According to the wood processing requirements of the guide rail, adjust the angle of the head and the steering wheel to be correct, and then cold pinch it off. Adjust the limit switch or travel iron.

8。 To start grinding, the grinding wheel of the workpiece must be contacted slowly. When using rapid feed, be careful not to let the grinding wheel and workpiece.

9。 Check, measure or adjust the size, and replace the grinding wheel. During grinding, after the grinding wheel stops for a certain distance, the workpiece. 10。 When the mill is working, workers are not allowed to use drilling tools to reduce the treatment conditions of pubic hair inkstone, nor are they allowed to contact and guide the treatment part, in order to avoid accidents.

11。 In the process of processing, if the knife element is found, or if the guide crawling fault is moving, it should be stopped. Continue operation after troubleshooting.

12。 After work, turn off the power, clean the machine tool and the working place, and add lubricating oil to the machine tool guide rail to prevent rusting.

13。 In case of work-related accidents, the equipment, in addition to rescuing the injured, shall keep the site and report to the relevant departments.